ide 보드구입후 테스트 해보는 도중에 나타나는 커널 메세지 입니다
잘은 모르겠지만 인식이 되지 않는 문제가 발생합니다
제품CD 이미지들 모두 올리고 테스트 했는데 잘 않되네요
답변 부탁드립니다


ttySA0 at MEM 0x80050000 (irq = 17) is a SA1100
pty: 256 Unix98 ptys configured
block: 64 slots per queue, batch=16
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 50MHz system bus speed for PIO modes; override with
idebus=xx
hdb: M`xtor 82460D2, ATA DISK drive
ide0: unexpected interrupt, status=0xfe, count=1
ide0 at 0xe0000000-0xe0000007,0xe000010c on irq 1
hdb: 5001728 sectors (2561 MB) w/256KiB Cache, CHS=5762/14/62
Partition check:
hdb:hdb: irq timeout: status=0xfe { Busy }
ide0: reset timed-out, status=0xfe
hdb: irq timeout: status=0xff { Busy }
ide0: reset timed-out, status=0xfe
end_request: I/O error, dev 03:40 (hdb), sector 0
end_request: I/O error, dev 03:40 (hdb), sector 2
end_request: I/O error, dev 03:40 (hdb), sector 4
end_request: I/O error, dev 03:40 (hdb), sector 6
end_request: I/O error, dev 03:40 (hdb), sector 0
end_request: I/O error, dev 03:40 (hdb), sector 2
end_request: I/O error, dev 03:40 (hdb), sector 4
end_request: I/O error, dev 03:40 (hdb), sector 6
unable to read partition table
ide0: unexpected interrupt, status=0xfe, count=2
eth0: cs8900 rev J Base 0xF0000300<6>, IRQ 47, MAC 00:D0:CA:F2:26:25
SA1100 flash: probing 16-bit flash bus
Using buffer write method
Using static partition definition
Creating 3 MTD partitions on "SA1100 flash":
0x00000000-0x00100000 : "Loader+Kernel"
0x00100000-0x00500000 : "Initrd"