아래와 같이 메세지가 뜨고 그냥 멈춰있습니다.
잘사용하다가 오늘 부팅할때 갑자기 이렇게 떴습니다.
이거 어떠게 해야되는지요? ㅜㅜ
대략 난감합니다.
혹시나해서 커널도 2.4.19와 램디스크 3.3.4를 다시 올렸는데도 똑같은 증상이 나타났습니다.
하드웨어 문제가 아닐까요?


Kernel command line:    initrd=0xa0800000,5M root=/dev/ram ramdisk=12288 console=ttyS02,115
Console: colour dummy device 80x30
Calibrating delay loop... 397.31 BogoMIPS
Memory: 64MB = 64MB total
Memory: 57940KB available (1364K code, 292K data, 68K init)
Dentry cache hash table entries: 8192 (order: 4, 65536 bytes)
Inode cache hash table entries: 4096 (order: 3, 32768 bytes)
Mount-cache hash table entries: 1024 (order: 1, 8192 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Using PXA255 frequency points.
Registering CPU frequency change support.
CPU clock: 398.131 MHz (99.000-400.000 MHz)
Starting kswapd
Journalled Block Device driver loaded
I2C: PXA algorithm module loaded.
I2C: Adding PXA-I2C-Adapter.
I2C: Scanning bus (68)
I2C: Successfully added bus
Console: switching to colour frame buffer device 80x30
LCD resolution 640x480
initialize_kbd: Keyboard reset failed, no ACK
Detected PS/2 Mouse Port.
PS2 Keyboard base:0xf1100000, irq:31 (gpio-8)
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with no serial options enabled
keyboard: Timeout - AT keyboard not present?(ed)
keyboard: Timeout - AT keyboard not present?(f4)
ttyS00 at 0x0000 (irq = 15) is a PXA UART
ttyS01 at 0x0000 (irq = 14) is a PXA UART
ttyS02 at 0x0000 (irq = 13) is a PXA UART
mk712 device OK!
I2C: DS1307 RTC driver successfully loaded
eth0: cs8900 rev K Base 0xF1000300<6>, IRQ 44, MAC 00:A2:55:F2:26:25
RAMDISK driver initialized: 16 RAM disks of 12288K size 1024 blocksize
loop: loaded (max 8 devices)