멀쩡하던.. 이지보드가 어느날 갑자기 안됨니다..ㅠ ㅠ

플레시가 지워졌는줄 알고 다시 구울려고 하니 이런 메시지만

뜬채 지워지지 않는군여..

------------------------------------------------------------
ezflash v1.2 ( 2002-01-15)
make by J.D&T Co.,Ltd ( You Young-chang, Oh Jae Kyoung )
============================================================
Options
-p : JTAG port test [ !!! single option ]
-c : SA1110 CELL test [ !!! single option ]
-f : INTEL FLASH test [ !!! single option ]
-r : Flash Read [ ]
-w : Flash Write [ default option ]
-v : Flash Verify [ ]
-b base : Flash base Address [ default : 0x00000000 ]
-o offset : Flash write Address [ default : 0x00000000 ]
-s size : Flash r/w size [ ]
------------------------------------------------------------
> Init JTAG Interface...
> 3 [-w]
------------------------------------------------------------
------------------------------------------------------------
> Flash Write From File....
> Setting Data
> Base Address : 0
> Offset Address : 0
> Size : 1580585
> File Name : ramdisk.gz
Put Bypass Value [ 01001000101010110111011011001011 ]
Get Bypass Value [ 10010001010101101110110110010110 ]
Bypass Passing Ok.
------------------------------------------------------------
Get ID Register Value [100010010010011000010000000100111110110110010110]
Stepping Value [1000] : Unknow stepping
Part Number [1001001001100001] : SA1110
Manufacturer ID [00000001001] : Intel Corporation
------------------------------------------------------------
# IR Setting..Value [00000]
Not Detect Intel Flash [ 90]
------------------------------------------------------------
program end

플레시 메모리가 나간건가여?? 별루 쓴것같지 않은데..

A/S가능한지 모르겠군여.. ㅠ ㅠ 도와주세여.. 프로젝트 3주

밖에 안남았는데..ㅠ ㅠ