도와주세요!!
2005.04.12 08:45:54 (*.241.183.7)
6641
[root@ez-x5 /]$ ifconfig
eth1 Link encap:Ethernet HWaddr 00:02:2D:C0:9F:5B
inet addr:192.168.4.58 Bcast:192.168.4.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:41 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:4449 (4.3 kiB) TX bytes:0 (0.0 iB)
Interrupt:36
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 iB) TX bytes:0 (0.0 iB)
[root@ez-x5 /]$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11-DS ESSID:"ds mobile" Nickname:"HERMES I"
Mode:Managed Frequency:2.437GHz Access Point:
00:01:F4:EC:9A:53
Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:12/92 Signal level:-83 dBm Noise level:-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@ez-x5 /]$
-------------------------------------------------------------------------
--
pcmcia 보드를 구입해서 ez-x5와 연결해서 사용하고 있습니다.
level이 항상 마이나스네요...
설정은 매뉴얼대로 따라 했구요.
무선랜 카드는 orinoco 사용하고 있습니다.
매뉴얼 외에 따른 설정이 더 필요한가요
cd에 리눅스용 디바이스드라이버가 있던데 포함시켜야 되는겁니까
미리 감사드립니다. 꾸벅..
eth1 Link encap:Ethernet HWaddr 00:02:2D:C0:9F:5B
inet addr:192.168.4.58 Bcast:192.168.4.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:41 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:4449 (4.3 kiB) TX bytes:0 (0.0 iB)
Interrupt:36
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 iB) TX bytes:0 (0.0 iB)
[root@ez-x5 /]$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11-DS ESSID:"ds mobile" Nickname:"HERMES I"
Mode:Managed Frequency:2.437GHz Access Point:
00:01:F4:EC:9A:53
Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:12/92 Signal level:-83 dBm Noise level:-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@ez-x5 /]$
-------------------------------------------------------------------------
--
pcmcia 보드를 구입해서 ez-x5와 연결해서 사용하고 있습니다.
level이 항상 마이나스네요...
설정은 매뉴얼대로 따라 했구요.
무선랜 카드는 orinoco 사용하고 있습니다.
매뉴얼 외에 따른 설정이 더 필요한가요
cd에 리눅스용 디바이스드라이버가 있던데 포함시켜야 되는겁니까
미리 감사드립니다. 꾸벅..
